Modify the network configuration for EIPs

This topic describes how to modify the network configuration for elastic IP addresses (EIPs) in the KubeSphere Virtualization (KSV) web console.

Prerequisites

• The user that you use has been granted the permissions to use the Physical Resources module. The Physical Resources module is available only to user admin.

• Make sure no subnets are created. Otherwise, the network configuration of EIPs cannot be modified.

Procedure

1. Log in to the KSV web console.

2. In the top navigation bar, click Physical Resources to go to the management page of physical resources.

3. In the left-side navigation pane, choose Networks > EIPs to go to the EIP network configuration page.

4. On the EIP Networks page, click Modify in the upper-right corner.

5. In the dialog box that appears, modify the network configuration for EIPs. The following table describes the parameters.

   Parameter	Description
   Physical Network	The name of the physical network used for EIPs.
   IP Range	The IP address range used for EIPs.
   VLAN	The VLAN ID that corresponds to EIPs.
   Gateway Address	The gateway address used for EIPs.
   Excluded IP Range	Click Advanced to exclude a single IP address or a specific range of IP addresses from the specified IP address range.

6. Click OK.